Origin Technologies LaserGauge Contour Application


	Contour Application


	Butt Weld Contour Corrosion Dents and Gouges Fasteners Fillet Weld Gap/Flush Lap Weld Part Alignment Pitting Radius Rivets Scratches Step Wear


	Measurements 1. Max - maximum height of the surface relative to the mean line through the surface.

2. Min - minimum depth of the surface relative to the mean line through the surface.
3. Depth - range of variation in the surface contour, Max minus Min.
4. Depth Average - average of depth for all scans taken with a single trigger.
5. Depth Standard Deviation - standard deviation of the depth for all scans taken with a single trigger.

Industry Examples
1. Building Materials - monitor surface pattern on composite residential siding board.
2. Stamping - inspect stamped surface for evidence of wear to tooling.
3. Aeronautics - quality check to specifications of external dimpling pattern on exhaust manifolds.


	Sensors and Controllers The size of the surface features being analyzed and the distance between those features will determine which sensor field-of-view is needed. This application normally requires a wider field-of-view as provided by the HS300 sensor. Any of the sensors and controllers could be used for this application.


	9238 Madison Blvd, Bldg 1, Ste 800 Madison, Alabama 35758 Phone 256-461-1313 Fax 256-461-1390 origintech.com