|
|||||||||
|
|||||||||
| Measurements
1. Step - difference in y distance between the surfaces of the two joined parts, shown as "Step" in the data table. |
| 2.
Runout - angle difference between the surfaces of the two joined parts,
shown as "Runout" in the data table.
Industry Examples
|
| Sensors
and Controllers
Sensor selection will be dependent on the size of the part and the field-of-view required to capture both sides of the joined part. Any of the sensors and controllers could be used for the application. Normally this type of measurement is made with an on-line system utilizing the Series 3000 controller with a RS400 sensor. |
||
|
Madison, Alabama 35758 Phone 256-461-1313 Fax 256-461-1390 origintech.com |
||